Description
The Bykski N-AS4070SDUALEVO-X is a full-cover GPU water block for the ASUS Dual GeForce RTX 4070 SUPER EVO 12GB. It replaces the original cooler and transfers heat from the GPU core, memory, and power stages to a custom liquid cooling loop. It includes a passive aluminum backplate and connects to the loop through G1/4 ports.
Match the exact card model and board layout.
Not compatible:
Before ordering, compare your card’s PCB layout and mounting holes with the board diagram in Installation & Use.
A T2 copper cold plate makes contact with the GPU core, memory, and voltage regulation components through their thermal interfaces. Coolant passes through 0.30 mm jet microchannels, visible through the clear acrylic top.
The passive black aluminum backplate mounts behind the PCB. Coolant stays in the front block.
For motherboard control, connect the RBW lighting to a 5V 3-pin ARGB header through a compatible adapter. You can also use a compatible 5V RBW controller. Do not connect the lighting to a 12V 4-pin RGB header.
| Model | N-AS4070SDUALEVO-X |
|---|---|
| Cold plate | T2 copper cold plate |
| Top | Clear PMMA acrylic |
| Backplate | Passive black aluminum |
| Cooling coverage | GPU core, memory, and VRM |
| Cold plate length | 145.46 mm |
| Copper plate thickness | 9 mm |
| Local copper base thickness | 0.35 mm (Bykski cross-section schematic) |
| Jet microchannels | 0.30 mm, up to 44 channels |
| Port thread | G1/4 inlet and outlet |
| Water block (L × W × T) | 189.87 × 146.01 × 26.25 mm |
| Backplate (L × W × T) | 189.87 × 116.01 × 6.00 mm |
| Lighting | 5V ARGB (RBW). Motherboard connection via adapter to a 5V 3-pin ARGB header. |
Use the full ASUS model name to find the block for your PCB.
Thermal paste is not included (it cannot be shipped by air). Please use your own thermal paste during installation.
You also need a pump, radiator, G1/4 tubing fittings, tubing, coolant, and your own thermal paste.
Check that the card is the ASUS Dual GeForce RTX 4070 SUPER EVO 12GB (DUAL-RTX4070S-12G-EVO). Match the PCB and mounting holes before ordering.
This block goes into a custom liquid cooling loop. It requires a separate pump, radiator, fittings, tubing, and coolant.
Use G1/4 fittings for the inlet and outlet. Use the included stop plugs to close the unused ports.
Use a compatible adapter to connect it to a 5V 3-pin ARGB motherboard header, or use a compatible 5V RBW controller. A 12V 4-pin RGB header can damage the lighting.
Place the supplied thermal pads on the memory and VRM contact areas shown in the installation diagram. Apply your own thermal paste to the GPU die.