G1/4 Manual Exhaust Valve for PC Water Cooling – Barrow TPQ-V2

Barrow · TPQ-V2

Manual air evacuation valve for PC water cooling

The Barrow TPQ-V2 is a manual air evacuation valve for custom PC water cooling loops. It screws into a spare G1/4 female port high in the loop, such as at the top of the reservoir. Press the front button to vent trapped air while filling and bleeding the loop and equalize pressure with the surrounding air.

Fits
G1/4 female port
Operation
Manual push button
Body diameter
20 mm

Fits / Use With

Use a spare G1/4 female port at a high point where air collects, such as the top of the reservoir.

Keep the front button accessible.

Design Highlights

Press the front button to vent air

Once the valve is installed, press the front button to let air out through the fitting. The valve stays threaded into the port during use.

Textured grip and separate color choices

The diamond-knurled body gives your fingers a grip as you thread the valve into place. Choose the body and the CD-pattern face colors in the product options.

Key Specifications

ModelTPQ-V2
Valve typeManual push-button air vent
MaterialsBrass and aluminum alloy
Mounting threadG1/4 male
Body diameter20 mm
Body height10.50 mm excluding the thread
Threaded section5 mm

Barrow dimension drawing. Measurements are in millimeters.

Which Version Do I Need?

Barrow TPQ-V2THIS PAGE
Choose this version if you want to vent the reservoir by pressing a button.
Choose this version if you want both automatic and manual air venting.

What's in the Box

1 × Barrow TPQ-V2 manual exhaust valve in the selected color combination

Installation & Use

1
For a reservoir installation, locate a free G1/4 female port on top of the reservoir, above the coolant level.
2
Thread the valve into the port using the knurled body for grip.
3
When air collects at the top during filling or bleeding, press the front button to vent it.
4
Release the button when you finish venting and check that the valve is closed.

FAQ

How do I let air out without removing the valve?

Leave the fitting threaded into the port and press the front button. Check that the valve is closed when you finish.

Where should I install the valve?

Use a spare G1/4 female port at a high point where air collects, such as the top of the reservoir.

How much room does the valve body take up?

The body is 20 mm across and 10.50 mm high. The threaded section adds 5 mm below the body.

Is it made of brass?

Barrow lists brass and aluminum alloy for the valve.

Notes
  • In case of product appearance structure upgrade,without further notice,in kind prevail