Server Integrated Pump Box, Barrow SPB17-TP 17W with Reservoir and Manual/PWM Control

Barrow · SPB17-TP

Integrated pump and reservoir for server liquid cooling loops

The Barrow SPB17-TP combines a 17W water pump and a reservoir in one factory-assembled unit for custom server liquid cooling loops. The reservoir sits inside the POM pump cover to save space. You can adjust pump speed with the manual knob or let a motherboard PWM header control it.

Fits
G1/4 loop fittings
Rated power
17 W
Max flow
960 L/h
Speed control
Manual or PWM

Loop Connections

Use G1/4 fittings that match the tubing in your custom loop.

Check the enclosure against Barrow’s dimension drawing. Leave room above the fill port and beside the pump for fittings and tubing.

The top port is for filling. On the side with two ports, the upper port is an inlet and the lower port is the outlet. The opposite side has a second inlet.

Design Highlights

Reservoir built into the pump cover

The POM cover holds coolant in the same assembly as the pump. The finned aluminum alloy housing helps the pump shed heat.

Two ways to set pump speed

The pump ships in PWM mode. Use the motherboard PWM header for automatic speed control, or turn the knob clockwise to switch to manual control.

Key Specifications

ModelSPB17-TP
ColorBlack
Overall size (L × W × H)80 × 62.2 × 70 mm
Base mounting hole spacing35 × 27 mm
Port threadG1/4
Rated electrical input12 V DC, 1.4 A, 17 W
Maximum flow960 L/h
Maximum head (Barrow spec)5–6 m
Maximum speed4,000 RPM
DriveSine wave
MaterialsAluminum alloy housing, POM pump cover, ceramic shaft
Weight380 g
Noise (Barrow spec)<40 dB

Barrow’s drawing. Measurements are in millimeters.

Which Version Do I Need?

Barrow SPB17-TPTHIS PAGE
Choose this integrated reservoir and pump for a custom server loop with manual or motherboard PWM speed control.
Choose this through-hole pump kit if your distribution plate specifies SPB17-T V2.
Compare this mini pump and reservoir kit for a compact PWM-controlled build.

What's in the Box

1 × factory-assembled SPB17-TP pump and reservoir

Installation & Use

1
Mount the pump as shown in Barrow’s installation diagram. Keep the top fill port accessible, and check the mounting hole spacing and tubing clearance.
2
Connect the return line to a side inlet and the outgoing line to the lower outlet. Seal any unused inlet.
3
Check that your 12 V DC power lead matches the pump’s power connector before connecting it. For PWM control, connect the separate PWM plug to a motherboard PWM header.
4
Add coolant through the top fill port before powering the pump. Keep the pump fed with coolant and never run it dry.
5
Leak-test the loop before powering the rest of the system.

For the rest of the loop, you’ll need G1/4 fittings, matching tubing, coolant, a radiator, and the appropriate water blocks.

Barrow’s example of fastening the pump from below.

FAQ

Do I need a separate reservoir or pump cover?

The SPB17-TP comes assembled with a reservoir built into the pump cover.

How do I switch between manual and PWM speed control?

Turn the knob clockwise to enter manual mode. Turn it fully counterclockwise to return to motherboard PWM control.

What flow rate and head does Barrow list?

Barrow lists a maximum flow rate of 960 L/h and a maximum head specification of 5–6 m.

Which port should I use to fill the pump?

Use the top G1/4 fill port. Connect your loop tubing to the side inlet and outlet shown in the port diagram.

Notes
  • In case product appearance upgrade, without further notice, prevail in kind.