Description
The Barrow LLO11-SDB XL is a frosted acrylic waterway plate for the original Lian Li O11 Dynamic XL. It brings the tubing connections for a single-GPU custom loop together on one plate beside the motherboard. Barrow uses G1/4 fittings for the loop and recommends a separate SPB17-T PLUS pump.
Not compatible:
Use the exact case model and check the port positions on your CPU and GPU blocks before ordering.
The included strip runs along the edge of the acrylic plate. Use a Barrow LRC 2.0 lighting controller or a conversion cable for a compatible 5V ARGB motherboard header.
The channels give the CPU block, GPU block, and radiators a shared place to connect their tubing. Plan the tube runs around the inlet and outlet on each block.
| Model | Barrow LLO11-SDB XL |
|---|---|
| Plate material | Frosted acrylic |
| Fitting thread | G1/4 |
| Lighting system | Barrow LRC 2.0, 5V 3-pin ARGB |
| Recommended pump | Barrow SPB17-T PLUS, 17W PWM, sold separately |
| Radiator layout shown by Barrow | Two 360 mm radiators, top and bottom |
| Motherboards listed by Barrow | View listed modelsASUS ROG Strix: Z390-E Gaming, Z390-H Gaming, Z370-E Gaming, Z370-F Gaming, Z370-H Gaming, B360-F Gaming, Z270E Gaming, Z270F Gaming, Z270H Gaming. ASUS ROG Maximus: XI Extreme, XI Gene, XI Hero, XI Hero Black Ops 4 Edition, X Hero, X Hero (Wi-Fi AC), IX Hero, VIII Extreme/Assembly, VIII Hero, VIII Ranger. Other ASUS models: Prime Z370-A, Prime Z390-A, Prime Z390-P, TUF Z370-Pro Gaming, TUF Z390-Pro Gaming, Z170 Pro Gaming, Z170-AR. |
| CPU blocks shown by Barrow | LTYK3-04 V2, LTYKB-04N-V2, LTYKB-ARK, LTFHB-04N V2, FBLTFHI-04N V2. |
Match the plate to your case model and preferred mounting position.
The With Manual Controller option adds a manual lighting controller. The No Controller option includes the same plate, strip, and mounting screws.
For the loop, you also need a pump, CPU and GPU water blocks, radiators, G1/4 fittings, tubing, and coolant.
It fits the original Lian Li O11 Dynamic XL. The O11 Dynamic EVO XL is a different case and is outside the stated fit.
Both options require a separate pump. Barrow recommends the SPB17-T PLUS through-hole PWM pump.
Use G1/4 fittings and choose fittings that match your tubing.
Use a compatible Barrow LRC 2.0 controller or a conversion cable to a compatible 5V ARGB motherboard header. Keep the 5V strip off 12V 4-pin RGB headers.