G1/4 Push Drain Valve for PC Water Cooling, Barrow TTLPFG V2

Barrow · TTLPFG V2

G1/4 push drain valve for custom PC water cooling

The Barrow TTLPFG V2 is a manual drain valve for custom PC water cooling loops. Its built-in G1/4 male inlet screws into a matching drain port. Slide the outer sleeve to let coolant out through a drain hose when you need to flush the loop or swap hardware.

Fits
G1/4 threaded ports
Control
Manual sliding sleeve
Materials
H59 brass and aluminum alloy

Fits / Use With

Match the G1/4 connections at each end.

  • ✓IN (male thread) connects to a G1/4 female port.
  • ✓OUT (female thread) accepts a G1/4 male fitting.

Install the valve so coolant travels from IN to OUT, following the markings on the body.

Design Highlights

Slide the sleeve to control flow

The outer sleeve moves along the valve body to open or close the flow path. Leave room to reach the sleeve after installing the valve.

Manufacturer drawing. Measurements are in millimeters.

Built-in male inlet

The male inlet screws into a matching G1/4 female port. Use the female outlet for a threaded fitting sized to your drain hose.

Key Specifications

ModelTTLPFG V2
Inlet threadG1/4 male
Outlet threadG1/4 female
MaterialsH59 brass and aluminum alloy
Body length34.70 mm (excludes protruding male thread)
Main body diameter23.90 mm
Inlet shoulder diameter17.30 mm
Outlet collar diameter18 mm

Which Version Do I Need?

Check the threads at the drain point and the room you have to operate the valve.

Barrow TTLPFG V2THIS PAGE
Choose this slide valve to connect a built-in male inlet directly to a matching female drain port.
Choose this handle-operated valve if your setup calls for two G1/4 female ports.

What's in the Box

1 × Barrow TTLPFG V2 drain valve

Installation & Use

1
On an empty loop, choose a G1/4 female port near the bottom of the loop for the drain branch. Screw the valve’s male IN end into that port.
2
Close the drain branch. After filling the loop, check the valve connections for leaks before powering the PC hardware.
3
To drain the loop, shut down the PC and stop the pump. Fit a drain hose to the OUT port with a matching G1/4 male fitting and lead the hose into a container.
4
Slide the sleeve to open the valve and drain the coolant. Close the valve before refilling the loop.

For draining, have a G1/4 male fitting that matches your hose, a drain hose, and a container for the coolant.

FAQ

How do I open and close the TTLPFG V2?

Move the outer sleeve along the valve body to open or close the flow path.

Which end connects to the loop’s drain port?

The male end marked IN screws into a G1/4 female port.

Can I attach a drain hose to it?

Yes. Use a G1/4 male hose fitting on the OUT end and match the fitting to your drain hose.

Does the 34.70 mm length include the male thread?

The drawing measures from the base of the male thread to the outlet end. Allow for the protruding thread and the fitting you add.

Notes
  • In case of product appearance structure upgrade,without further notice,in kind prevail