Barrow · ABQYG-16A V2
Multi-angle bending mold for PC water cooling
The Barrow ABQYG-16A V2 is a bench-top mold for shaping 12, 14, or 16 mm OD acrylic (PMMA) and PETG hard tubing in a custom PC cooling loop. Three adjustable guide arms position the softened tube along your planned route. Set the guides for a corner, an offset, or a U-bend, then hold the tube in place as it sets.
Tube materials
Acrylic (PMMA) / PETG
Guide arms
3 adjustable ABS arms
Use With
Check your hard tubing’s outside diameter (OD) before ordering.
- ✓12 mm OD acrylic (PMMA) or PETG hard tubing
- ✓14 mm OD acrylic (PMMA) or PETG hard tubing
- ✓16 mm OD acrylic (PMMA) or PETG hard tubing
Match the silicone bending insert to the inside diameter of your tubing.
Design Highlights
Set the guides for your tube route
Reposition the guide arms in the straight or curved slots to suit the bend. The scale along the base shows center-to-center spacing.
Barrow’s guide layout for a parallel offset.
Shift the tube sideways with an offset
Barrow shows two guides positioning the tube so its straight ends run parallel on either side of the offset.
Key Specifications
| Model | ABQYG-16A V2 |
|---|
| Color | Black |
|---|
| Supported tube OD | 12 mm, 14 mm, or 16 mm |
|---|
| Tube materials | Acrylic (PMMA) or PETG rigid tubing |
|---|
| Guide material | ABS plastic |
|---|
| Base plate (L × W × T) | 435.80 × 119.30 × 16 mm |
|---|
Barrow’s base plate drawing. Dimensions are in millimeters.
Which Version Do I Need?
Barrow ABQYG-16A V2THIS PAGE
Choose this adjustable mold if you need to change the bend layout or work with more than one supported tube diameter.
Choose an AWGM3 set for fixed-angle bends in one tube size. Select the set by your tube’s outside diameter.
What's in the Box
1 × black bending mold setBase plate3 × guide armsBolts and thumb knobs
Barrow’s view of the mold before assembly.
How to Bend Hard Tubing
1Plan the tube route and set the guide arms to match the bend you want.
2Slide a silicone insert that fits the tube’s inside diameter into the section you plan to bend.
3Rotate the tube over a heat gun so the bend area softens evenly. Keep the hot air away from the mold and avoid touching the heated tube.
4Move the softened tube to the mold and bend it against the guides in one smooth motion. Hold the bend in place until it sets.
5Remove the insert, check the tube against your route, then trim and deburr the ends as needed.
Have hard tubing, a heat gun, a silicone bending insert, and suitable cutting and deburring tools on hand. The Barrow GJSGW silicone bending cord is available separately.
FAQ
What size acrylic or PETG tube fits this mold?
Use rigid tubing with an outside diameter of 12, 14, or 16 mm. PMMA is acrylic.
What bend shapes can I make?
Barrow shows setups for a single corner, a parallel offset, and a U-shaped return. Move the guide arms to set up the bend for your route.
How do I size the silicone bending insert?
Choose an insert that fits the inside diameter of the tube. It supports the tube wall from the inside while you bend it.
Where do I aim the heat gun?
Heat the section of tubing you want to bend and keep the hot air away from the ABS guides.
Notes- Barrow may update the tool’s appearance or construction without notice.