Barrow · BS-PAT5090-PA
Palit RTX 5090 GameRock GPU Water Block
The Barrow BS-PAT5090-PA replaces the stock cooler on supported Palit GeForce RTX 5090 GameRock cards so you can connect the GPU to a custom liquid cooling loop. Its copper cold plate draws heat from the GPU core, memory, and power delivery components. An aluminum alloy backplate is included.
Fits
Palit RTX 5090 GameRock
Compatibility
Barrow lists these two Palit models for this block.
- ✓Palit GeForce RTX 5090 GameRock
- ✓Palit GeForce RTX 5090 GameRock OC
Verify your card’s exact model and PCB layout before ordering.
GameRock on the left and GameRock OC on the right.
Key Specifications
| Model | BS-PAT5090-PA |
|---|
| Cold plate | Copper |
|---|
| Top | Clear acrylic |
|---|
| Backplate | Aluminum alloy |
|---|
| Color options | Black or white backplate |
|---|
| Block size (L × W × max. T) | 208.10 × 151.60 × 24.20 mm |
|---|
| Inlet and outlet thread | G1/4 |
|---|
| Lighting | 5V 3-pin addressable RGB |
|---|
What's in the Box
1 × Full-cover GPU water block1 × Aluminum alloy backplate2 × G1/4 stop plugs1 × Mounting hardware set1 × Thermal pad set
Thermal paste is not included (it cannot be shipped by air). Please use your own thermal paste during installation.
Installation & Use
1Remove the stock cooler and backplate, then clean off the old thermal material.
2Apply your own thermal paste to the GPU die. Cut and place the pads according to the numbered diagram.
3Fit the block and backplate with the supplied mounting hardware.
4Connect your loop to the designated inlet and outlet, close the unused ports with the supplied plugs, and leak-test before powering the graphics card.
Use G1/4 fittings that match your tubing. For motherboard lighting control, use a separately purchased adapter cable for the 5V 3-pin ARGB header.
Place the included thermal pads in the areas shown.
FAQ
Does it fit the GameRock OC?
Yes. Barrow lists both the Palit RTX 5090 GameRock OC and the standard GameRock. Check your PCB layout before ordering.
Can I connect the lighting to my motherboard?
Use a 5V 3-pin ARGB header with a separately purchased adapter cable. A 12V 4-pin RGB header is incompatible.
What fittings do I need?
Use G1/4 fittings sized for your tubing. The box includes two stop plugs for unused ports.
Notes- 2. This is a repair or replacement-only item. Returns are not accepted in principle on compatibility issues or if the block has had water/fluid run through it.
- 3. The manufacturer reserves the right to alter the block design to expand compatibility or upgrade/modify the product. The delivered item may not 100% match the pictured item.
- 4. Not responsible for any damage caused by or when using this product. Please use it at your own risk.