32%OFF

PCIe Water Cooling Pass-Through Bracket, Dual G1/4 – Barrow GJTPC-01

Barrow · GJTPC-01

Route a custom loop through a spare PCIe slot

The Barrow GJTPC-01 is a dual-channel water cooling pass-through that replaces the cover on one spare rear PCIe expansion slot. Two G1/4 female ports on each side connect your PC’s internal tubing to an external radiator, giving the outgoing and return lines a route through the same slot.

Fits
One rear expansion slot
Ports
G1/4 female
Port spacing
30 mm center to center
Body
Black POM

Fits / Use with

  • ✓One spare rear PCIe expansion slot opening
  • ✓G1/4 male tubing fittings

Before ordering, check the space around the slot on both sides of the case. Use the 30 mm port spacing to check clearance between adjacent fittings.

Design Highlights

POM body on a steel bracket

The carbon steel bracket mounts in the chassis slot and holds the black POM port body across the rear panel.

Threaded connections inside and out

Both ends of each pass-through channel accept a male G1/4 fitting. The bracket gives the outgoing and return tubing runs separate connections at the case wall.

Key Specifications

ModelGJTPC-01
Body materialPOM (acetal)
Bracket materialCarbon steel
ColorBlack
Pass-through channels2
Threaded ports4 × G1/4 female, two per side
Port body (W × H × D)50 × 18 × 29.90 mm
Port spacing30 mm center to center

Barrow drawing of the port body. Measurements are in millimeters.

Which Version Do I Need?

Choose by where you want the coolant lines to cross the case wall.

Barrow GJTPC-01THIS PAGE
Use this POM-body bracket for an outgoing line and a return line through one expansion slot.
Choose this bracket if you prefer a brass port body for dual G1/4 routing through an expansion slot.
Choose this fill port if you need a single G1/4 connection through a case panel.

What's in the Box

1 × GJTPC-01 pass-through bracket assembly

Installation & Use

1
Remove the cover from an unused rear expansion slot.
2
Secure the bracket at the case’s slot mounting point. Align the port body on the bracket and secure it with the center screw as shown.
3
Install the G1/4 fittings and connect the internal tubing and external radiator lines.
4
Leak-test the loop before powering on the computer.

You’ll also need G1/4 male fittings and tubing sized to match them.

Barrow mounting illustration. The blue outlines show the bracket, port body, and mounting points.

FAQ

What is a PCIe water cooling pass-through used for?

It routes the outgoing and return coolant lines to an external radiator through a slot opening that’s already in the case.

What fittings fit the G1/4 ports?

Use male G1/4 fittings sized for your tubing. Match the inner and outer diameters for soft-tube compression fittings, or the outer diameter for hard-tube fittings.

Does the port body come off the bracket for mounting?

Barrow’s installation drawing shows the port body separated at the bracket. A center screw holds it in place when assembled.

Are tubing fittings included?

Plan to supply your own G1/4 fittings. The box contains one pass-through bracket assembly.

Notes
  • Note: In case of product appearance structure upgrade,without further notice,in kind prevail