Description
The Barrow ASSGR701-SDB is an acrylic waterway board for a custom liquid cooling loop in the ASUS ROG Hyperion GR701 case. It brings the tubing runs for the pump, radiators, CPU block, and GPU block together at a single mounting location. The board has a built-in coolant chamber and ports for G1/4 fittings.
Check your case model before ordering.
The board mounts vertically between the motherboard tray and the front of the case.
The chamber and channels are built into the same plate. Run your tubing from the loop components to the corresponding ports in Barrow’s layout.
Threaded inserts in the rear mounting holes take the case mounting screws and protect the acrylic threads.
The LRC 2.0 Aurora strip lights the edge of the plate. Use a Barrow ARGB adapter cable for motherboard control, or choose the manual controller option to adjust the lighting by hand.
| Manufacturer model | ASSGR701-SDB |
|---|---|
| Plate material | Acrylic |
| Coolant port thread | G1/4 |
| Lighting system | Barrow LRC 2.0 Aurora |
| Motherboard lighting connection | 5V 3-pin ARGB via a Barrow adapter cable |
| Controller options | No Controller or With Manual Controller |
Choose by how much of the GR701 loop you want to assemble from separate parts.
Select “With Manual Controller” to add one manual lighting controller.
For the setup shown, supply a pump, radiators, CPU and GPU water blocks, tubing, fittings, and coolant separately.
It mounts vertically between the motherboard tray and the front of the case. Start the screws loosely and tighten them after aligning the tubing.
Barrow’s GR701 layout shows the SPB17-T V2 through-hole pump. Supply it separately with either board option.
Yes. Connect the strip through a Barrow ARGB adapter cable. For motherboard control, use only a 5V 3-pin ARGB header.
Use G1/4 fittings at the board’s coolant ports.