Frosted Acrylic Tubing for PC Water Cooling, 12/14/16 mm OD | Bykski CB-PMMAFR

Bykski · CB-PMMAFR

Frosted acrylic hard tubing for custom PC water cooling

Bykski CB-PMMAFR is rigid acrylic tubing with a translucent frosted finish. It carries coolant between components in a custom PC water cooling loop and fits hard-tube fittings sized to its outside diameter. Cut it to suit your layout and heat-bend it where the route changes direction.

Material
PMMA acrylic
Finish
Translucent frosted
Fits
12, 14, or 16 mm OD acrylic hard-tube fittings

Use with

Match the fitting to the tube’s outside diameter (OD).

  • ✓12 × 8 mm tubing → 12 mm OD hard-tube fittings for acrylic
  • ✓14 × 10 mm tubing → 14 mm OD hard-tube fittings for acrylic
  • ✓16 × 12 mm tubing → 16 mm OD hard-tube fittings for acrylic

Use the inside diameter (ID) when choosing a silicone bending insert.

Key Specifications

Model seriesCB-PMMAFR
MaterialPMMA acrylic
FinishTranslucent frosted
Tube sizes (OD × ID)12 × 8 mm, 14 × 10 mm, 16 × 12 mm

What's in the Box

Bykski CB-PMMAFR frosted acrylic tubing

Installation & Use

1
Measure the run between the fittings and account for how far the tube seats in each fitting.
2
For bends, slide a matching silicone insert into the tube. Heat the bend area evenly with a heat gun and shape it around a bending mandrel. Let the tube set, then remove the insert.
3
Cut the tube to final length with a hacksaw. Chamfer and deburr the ends, then clear out any cutting debris.
4
Seat the tube in the matching fittings and leak-test the loop before powering on the PC.

FAQ

Is frosted acrylic tubing translucent?

Yes. This PMMA acrylic tube has a translucent frosted finish.

Which fitting fits a 14 × 10 mm tube?

Use a 14 mm OD fitting rated for acrylic hard tubing. The 10 mm measurement is the inside diameter.

Can I bend the tube to fit my loop?

Yes. Use a heat gun, a silicone insert that matches the tube’s inside diameter, and a bending mandrel.