Bykski · CB-PMMAFR
Frosted acrylic hard tubing for custom PC water cooling
Bykski CB-PMMAFR is rigid acrylic tubing with a translucent frosted finish. It carries coolant between components in a custom PC water cooling loop and fits hard-tube fittings sized to its outside diameter. Cut it to suit your layout and heat-bend it where the route changes direction.
Finish
Translucent frosted
Fits
12, 14, or 16 mm OD acrylic hard-tube fittings
Use with
Match the fitting to the tube’s outside diameter (OD).
- ✓12 × 8 mm tubing → 12 mm OD hard-tube fittings for acrylic
- ✓14 × 10 mm tubing → 14 mm OD hard-tube fittings for acrylic
- ✓16 × 12 mm tubing → 16 mm OD hard-tube fittings for acrylic
Use the inside diameter (ID) when choosing a silicone bending insert.
Key Specifications
| Model series | CB-PMMAFR |
|---|
| Material | PMMA acrylic |
|---|
| Finish | Translucent frosted |
|---|
| Tube sizes (OD × ID) | 12 × 8 mm, 14 × 10 mm, 16 × 12 mm |
|---|
What's in the Box
Bykski CB-PMMAFR frosted acrylic tubing
Installation & Use
1Measure the run between the fittings and account for how far the tube seats in each fitting.
2For bends, slide a matching silicone insert into the tube. Heat the bend area evenly with a heat gun and shape it around a bending mandrel. Let the tube set, then remove the insert.
3Cut the tube to final length with a hacksaw. Chamfer and deburr the ends, then clear out any cutting debris.
4Seat the tube in the matching fittings and leak-test the loop before powering on the PC.
FAQ
Is frosted acrylic tubing translucent?
Yes. This PMMA acrylic tube has a translucent frosted finish.
Which fitting fits a 14 × 10 mm tube?
Use a 14 mm OD fitting rated for acrylic hard tubing. The 10 mm measurement is the inside diameter.
Can I bend the tube to fit my loop?
Yes. Use a heat gun, a silicone insert that matches the tube’s inside diameter, and a bending mandrel.