Sapphire METAL RX 9070 XT Water Block with Backplate, Bykski A-SP9070XTMT-X

Bykski · A-SP9070XTMT-X

Full-cover GPU water block for Sapphire METAL RX 9070 XT

The Bykski A-SP9070XTMT-X replaces the stock cooler on the Sapphire METAL Radeon RX 9070 XT 16GB and connects the card to a custom liquid cooling loop. Its copper cold plate removes heat from the GPU core, memory, and voltage regulators. The included aluminum backplate mounts behind the card’s circuit board.

Fits
Sapphire METAL RX 9070 XT
Port thread
G1/4
Lighting
5V 3-pin ARGB

Compatibility

Bykski lists one card layout for this block.

  • ✓Sapphire METAL Radeon RX 9070 XT 16GB GDDR6 (11348-07-78)

Before ordering, confirm the model number on your card and match its PCB layout to Bykski’s compatibility diagram.

Sapphire METAL RX 9070 XT with its stock cooler.

Key Specifications

ModelA-SP9070XTMT-X
CoverageGPU core, memory, and VRM
Cold plateCopper
TopClear acrylic (PMMA)
BackplateBlack aluminum
Dimensions (L × W × T)195.45 × 137.00 × 26.15 mm (Bykski drawing)
Port threadG1/4
Lighting5V 3-pin addressable RGB (RBW)

Which Version Do I Need?

Bykski A-SP9070XTMT-XTHIS PAGE
For the Sapphire METAL RX 9070 XT 16GB, check for card number 11348-07-78 and match your PCB to Bykski’s compatibility diagram.
For an XFX Mercury RX 9070 XT OC Gaming 16GB, check the PCB layout listed for this separate block.

What's in the Box

1 × full-cover GPU water block1 × aluminum backplateThermal padsMounting hardware2 × G1/4 stop plugs

Thermal paste is not included (it cannot be shipped by air). Please use your own thermal paste during installation.

Installation & Use

1
Power off the system, remove the graphics card, and take off the stock cooler. Clean away the old thermal paste and pad residue.
2
Place the thermal pads as shown in Bykski’s installation diagram. Apply your own thermal paste to the GPU die only.
3
Align the block and backplate with the PCB and secure them with the supplied mounting hardware. Tighten the block evenly.
4
Connect the block to your loop using G1/4 fittings and seal unused ports with the supplied plugs.
5
Leak-test the loop with the graphics card unpowered.

You also need a pump, radiator, G1/4 fittings, tubing, and coolant.

FAQ

Which RX 9070 XT does this water block fit?

Bykski lists the Sapphire METAL RX 9070 XT 16GB. Match the card number 11348-07-78 and compare your PCB with Bykski’s compatibility diagram before ordering.

Which motherboard header does the lighting use?

Connect the lighting to a 5V 3-pin ARGB header.

What fittings do I need?

Use G1/4 fittings sized for your tubing.

Notes
  • Keep the lighting cable off 12V RGB headers. The block’s LEDs require 5V ARGB.