Bykski · B-DTH-K40-V5
Air pressure leak tester for custom water cooling loops
The Bykski B-DTH-K40-V5 is a hand-pumped leak tester for custom PC water cooling loops. Connect its air hose to a G1/4 port on the assembled loop to check whether it holds air pressure before you add coolant. Watch the gauge needle for a drop in pressure during the test.
Fits / Use With
Use an open G1/4 threaded port on your assembled custom PC water cooling loop.
Key Specifications
| Model | B-DTH-K40-V5 |
|---|
| Loop connection | G1/4 |
|---|
| Pump type | Manual push-pull air pump |
|---|
| Gauge | Analog dial, bar and psi |
|---|
| Tester length (pump rod retracted) | 175 mm |
|---|
| Gauge width | 41 mm |
|---|
| Air hose length | 188 mm |
|---|
| Pressure release | Side push-button |
|---|
What's in the Box
1 × leak tester set with hand pump, dial gauge, and air hose
How to Check for Leaks
1Connect the air hose to the tester, then screw the other end into an open G1/4 port on the assembled loop.
2Use the hand pump to raise the air pressure while watching the gauge. Stay within the test pressure limits of your loop components.
3Stop pumping and watch the gauge for about 10 seconds. If the pressure drops, check the tubing and fittings for leaks.
4Press the side button to release the air pressure before disconnecting the tester.
FAQ
Does the leak tester need coolant in the loop?
The tester uses air to check the assembled loop before you fill it with coolant.
What fitting does it connect to?
The air hose screws into an open G1/4 threaded port on the loop.
What does a falling gauge reading mean?
A pressure drop is a sign to check the loop for air leaks, including at the tubing connections.
Notes- Not responsible for any damage caused by or when using this product. Please use at your own risk.