PC Water Cooling Flow Meter & OLED Thermometer, Bykski B-TFC-CS-X

Bykski · B-TFC-CS-X

Inline OLED flow meter and coolant thermometer

The Bykski B-TFC-CS-X is an inline flow meter and thermometer for custom PC water cooling loops. Its OLED shows coolant temperature, flow rate, and sensor rotor speed at a glance. An on-screen warning flags abnormal flow, and two G1/4 ports let you install the meter between tubing runs.

Fits
G1/4 male fittings
Display
Glass-fronted OLED
Ports
2 × G1/4 female
Housing
Black POM

Fits

Both ports accept G1/4 male fittings.

Choose hard-tube fittings by the tube’s outside diameter. For soft-tube compression fittings, match both the inside and outside diameters.

Facing the display, the right port is the inlet and the left port is the outlet in the factory setup.

Left-side port shown. This is the outlet in the factory setup.

Design Highlights

Live readings and flow alerts

The display shows coolant temperature, flow rate, and the meter’s own rotor speed at the same time. If coolant flow is interrupted, such as when the pump stops, the screen shows a warning.

Two ports, one inline connection

The POM housing has a G1/4 port at each end. The glass-fronted OLED faces forward for reading once the meter is plumbed into the loop.

Key Specifications

ModelBykski B-TFC-CS-X
Black SKUB-TFC-CS-X_BK
HousingBlack POM (acetal)
DisplayGlass-fronted OLED
ReadoutsCoolant temperature (°C), flow rate (L/min), and rotor speed (rev/s)
Ports2 × G1/4 female
Dimensions (W × H × D)65 × 32 × 35 mm
Default flow directionRight to left when facing the screen

Bykski dimension drawing. Front view on the left, port-side view on the right.

Flow Meter or Flow Indicator?

Bykski B-TFC-CS-XTHIS PAGE
Choose this meter to read coolant temperature and flow rate on the built-in OLED.
Choose the three-port flow indicator if you only need to see whether coolant is moving.

What's in the Box

1 × black Bykski B-TFC-CS-X OLED flow meter and thermometer

Installation & Use

1
Plan a spot in the tubing run where you can see the display and reach both ports.
2
Check the flow direction before connecting the tubing. For a left-hand inlet, reverse the rotor before installing the meter.
3
Attach a G1/4 male fitting to each port, then connect the tubing to the fittings.
4
Leak-test the loop with only the pump powered, and check both meter connections before powering the rest of the PC.

You also need two G1/4 male fittings sized for your tubing and the tubing to connect the meter to your loop.

Bykski installation drawing showing the meter between two tubing runs.

FAQ

What does the OLED show?

It shows coolant temperature in °C, flow rate in L/min, and the meter’s rotor speed in revolutions per second.

Can I install it with flow going from left to right?

Yes. Before installation, loosen the left-side retainer with an 8 mm hex key. Take out the rotor, turn it 180°, reinstall it, and tighten the retainer.

What does the flow warning mean?

The meter has detected abnormal coolant flow. A stopped pump is one example of a condition that can bring up the warning.

Which Bykski flow meter is listed here?

This listing is for the black B-TFC-CS-X, SKU B-TFC-CS-X_BK. Check the full part number when comparing listings.

Notes
  • When reversing the rotor, the recessed end faces the inlet and the flatter end faces the outlet.