GPU Water Block 90° Rotary Terminal, G1/4 – Bykski B-VGA-MINI-X

Bykski · B-VGA-MINI-X

90° rotary terminal for Bykski GPU water blocks

The Bykski B-VGA-MINI-X is a low-profile brass terminal that replaces the stock terminal on a compatible Bykski GPU water block. Its two 90° elbows each swivel through 360°, so you can aim the G1/4 fittings to route tubing around nearby components in a tight case.

Fits
Compatible Bykski GPU blocks
Fitting thread
G1/4
Swivel
360° per elbow

Fits / Use With

  • ✓Bykski GPU water blocks with a matching terminal mount
  • ✓G1/4 tubing fittings

Before ordering, check the exact water block model and confirm that the mounting holes and sealing surfaces match the original terminal.

Key Specifications

ModelB-VGA-MINI-X
MaterialBrass
Fitting ports2 × G1/4
Elbow angle90°
Swivel range360° per elbow
Base plate (L × W)73.48 × 20.00 mm
Height from bottom of base to top of elbow27.98 mm
ColorsBlack or silver

What's in the Box

1 × B-VGA-MINI-X rotary bridge module

Installation & Use

1
Remove the stock terminal from the water block.
2
Seat the sealing rings, align the mounting holes, and secure the rotary terminal. Avoid overtightening screws in acrylic.
3
Aim the elbows for your tubing route, then attach your G1/4 fittings and connect the tubing.
4
Leak-test the loop before powering the graphics card. The installation guide recommends a 24-hour test.

Example tubing routes with the elbows turned in different directions.

FAQ

What fittings and tubing can I use?

Use G1/4 fittings sized for your hard or soft tubing.

How far can I turn the elbows?

Each 90° elbow swivels through 360° so you can aim the fitting to suit your tubing route.

Notes
  • Not responsible for any damage caused by or when using this product. Please use it at your own risk.