Description
The Bykski N-TESLA-A30X-24G-SR is a full-cover GPU water block with an aluminum backplate for the NVIDIA A30X 24GB PCIe accelerator. It replaces the card’s stock passive heatsink and transfers heat from the card into a custom liquid cooling loop. The nickel-plated T2 copper cold plate has raised contact surfaces across the PCB, and G1/4 ports connect the block to the loop.
Supported board layout
Compare the PCB layout and mounting holes with the photo before ordering.
The 228.5 mm T2 copper cold plate has raised contact surfaces for the card’s heat-producing components. A nickel finish protects the copper surface. The separate aluminum backplate sits outside the coolant path.
Coolant passes through a jet microchannel section with up to 44 channels. The narrow channels increase the surface area in contact with the coolant.
Both ports use G1/4 female threads.
| Model | N-TESLA-A30X-24G-SR |
|---|---|
| Cold plate | Nickel-plated T2 copper |
| Copper material conductivity | 401 W/(m·K) |
| Panel | 304 stainless steel |
| Backplate | Black aluminum |
| Block dimensions (L × W × T) | Approx. 267.5 × 99.8 × 27.3 mm |
| Backplate dimensions (L × W × T) | Approx. 249.8 × 95.1 × 5.0 mm |
| Net weight | 1.3 kg |
| Port threads | G1/4 female |
| Seal | EPDM |
| Maximum working pressure | 2 bar |
| Block temperature range | −20 to 60°C |
| Fluids listed for the block | Water, ethylene glycol, propylene glycol, fluorinated fluid, or mineral oil. Check compatibility with every component in your loop. |
Both cooling options are designed for the A30X 24GB board shown above.
Thermal paste is not included (it cannot be shipped by air). Please use your own GPU thermal paste during installation.
You also need a pump and reservoir, a radiator and fans, G1/4 fittings matched to your tubing, tubing, and coolant.
The stock A30X is a passively cooled PCIe card rated for up to 230 W. This block replaces its passive heatsink for use in a custom liquid cooling loop.
Bykski lists the A30X PCB only. The NVIDIA A30 is a separate accelerator model, so check the full model name and PCB before ordering.
Yes. The water block connects to a custom cooling loop with its own pump, reservoir, radiator, and fans.
Use 1.5 mm thermal pads cut to fit the red areas in the installation diagram. Apply your own GPU thermal paste to the GPU die outlined in blue.
The block measures about 267.5 × 99.8 × 27.3 mm. Use the dimension drawing and allow space for the fittings and tubing at the end of the card.