Description
The Bykski B-PCTOOL-X guides bends in rigid acrylic and PETG tubing for custom PC water cooling. Set the guide arms on the slotted base to match the angles and spacing you need. Then bend the softened tube against the guides to follow your planned route, including runs that need more than one bend.
Use with rigid acrylic or PETG tubing in these outside diameters.
For the silicone bending insert, check the tube’s inside diameter separately.
Move a guide arm along the curved track and tighten it at the angle you need. The guide gives the softened tube a surface to bend against.
Use the distance scale and straight slots to position the guides when your route calls for a measured gap between bends.
Reposition the arms to make an offset when two fittings sit out of line. The guides can also be rearranged for successive bends on the same tube.
| Model | B-PCTOOL-X |
|---|---|
| Color | Black |
| Tubing materials | Rigid acrylic and PETG |
| Tube outside diameter | 12, 14, and 16 mm |
| Base (L × W × T) | 435 × 119 × 16 mm |
| Tool weight | 325 g |
Have rigid tubing, a heat gun, a matching silicone bending insert, a tube-cutting tool, and a chamfering tool on hand.
Yes. Use rigid acrylic or PETG with an outside diameter of 12, 14, or 16 mm.
Yes. Reposition the guide arms for the shape you need. The example above shows two right-angle bends on one tube.
It can sit on a stable work surface while you bend the tube.
Yes. The jig guides the tube after heating. Use a separate heat gun and a silicone insert sized for the tube’s inside diameter.