Bykski · B-PRE-SC-V2
Digital pressure gauge for custom PC water cooling
The Bykski B-PRE-SC-V2 is an inline digital pressure gauge for custom PC water-cooling loops. Its built-in OLED shows the current coolant pressure in hectopascals (hPa) and displays short-term changes so you can follow pressure while the loop is running. It connects between two fittings in the coolant line.
Fits & Use With
For custom PC water-cooling loops with G1/4 male tubing fittings.
For the hard-tube setup shown below, choose fittings that match your tubing’s outside diameter. Allow room for the fittings and tubing at both ends.
Design Highlights
Manufacturer illustration with an example pressure reading.
Read pressure as the loop runs
The OLED shows the current reading in hPa. A bar shows how pressure changed over a 12-second interval.
Threaded ports at both ends
Each end has a G1/4 female port. The manufacturer’s hard-tube setup uses one tube fitting on each side of the gauge.
Key Specifications
| Model | B-PRE-SC-V2 |
|---|
| Housing | Black POM |
|---|
| Front panel | Glass |
|---|
| Display | OLED |
|---|
| Pressure unit | hPa (hectopascals) |
|---|
| Ports | 2 × G1/4 female |
|---|
| Body size (L × D × H) | 65 × 35 × 32 mm |
|---|
Manufacturer drawing. Dimensions are in millimeters.
Pressure Gauge, Flow Meter, or Leak Tester?
Bykski B-PRE-SC-V2THIS PAGE
Choose this inline gauge to read the coolant pressure while your loop runs.
Choose this digital flow meter and thermometer to read coolant flow and temperature.
Choose this manual air-pressure tool to check a custom loop for leaks.
Included gauge
1 × black Bykski B-PRE-SC-V2 pressure gauge
Installation & Use
1Shut down and unplug the PC. Drain the coolant if you’re adding the gauge to an existing loop.
2Choose a spot in the tubing run where you can read the screen and reach both fittings.
3Thread one G1/4 male hard-tube fitting into each end of the gauge, seat the seals, and connect the tubing on both sides.
4Refill and bleed the loop. With the PC hardware off, run the pump for a leak test and check both new joints. Bykski suggests a typical test time of 24 hours.
5Once the loop is ready to run, read the coolant pressure in hPa on the OLED.
For this setup, you’ll need two G1/4 male hard-tube fittings sized for your tubing, plus tubing and coolant for the loop.
Bykski’s example with hard tubing and one fitting at each end.
FAQ
What does the pressure gauge measure?
It reads coolant pressure as your custom PC loop runs. The OLED reports the reading in hPa.
What fittings do I need for hard tubing?
Use two G1/4 male hard-tube fittings sized for the outside diameter of your tubing.
What appears on the OLED at startup?
The startup logo gives way to a live reading after about five seconds. A bar shows pressure changes over a 12-second interval.
How much room does the gauge need?
The body is 65 mm long, 35 mm deep, and 32 mm tall. Leave room for a fitting and tubing at each end.
Notes- Not responsible for any hardware damage. Use at your own risk.