Description
The FormulaMod Fm-M124P is a 700 mm sleeved cable that connects a compatible ATX 3.0 power supply with a native 12VHPWR port directly to a supported graphics card with a 12VHPWR power socket. The 90° GPU plug lets the cable turn at the socket. Match the plug orientation to your card and check the available clearance.
Check the power supply and graphics card before ordering.
Not compatible:
Confirm with your power supply manufacturer that your exact PSU model supports this cable. If compatibility is unconfirmed, use a cable approved by your PSU manufacturer.
The straight plug connects at the power supply. At the graphics card, the angled plug turns the cable along the card.
Choose Type-Z if the four small signal contacts on your GPU power socket are on the side closest to the backplate.
Choose Type-F if the latch side of your GPU power socket is closest to the backplate.
| Model series | Fm-M124P |
|---|---|
| Cable length | 700 mm |
| GPU power interface | PCIe 5.0 12VHPWR |
| GPU plug | 90° 16-pin (12+4) male |
| PSU plug | Straight 16-pin (12+4) male |
| Wire | 16 AWG tinned copper |
| Sleeving | Individually braided |
| Type-Z, black | Fm-M124P-BKP124-BK-90Z-700 |
| Type-Z, white | Fm-M124P-WTP124-WT-90Z-700 |
| Type-F, black | Fm-M124P-BKP124-BK-90F-700 |
| Type-F, white | Fm-M124P-WTP124-WT-90F-700 |
Start with where the cable needs to connect. A 16-pin male-to-female extension adds length to an existing compatible GPU cable.
You need a compatible power supply and graphics card, plus enough room around the GPU socket for the selected plug orientation.
Yes. The right-angle plug connects to the graphics card, and the straight plug connects to the power supply.
Look at the side of the GPU power socket nearest the backplate. Choose Type-Z if the four small signal contacts are on that side, or Type-F if the latch is on that side.
This cable requires a native 16-pin 12VHPWR port on a compatible ATX 3.0 power supply. Confirm support for this cable with the manufacturer of your exact PSU model.
Leave enough room for the plug to sit flush and latch fully. Route the cable with slack so the side panel can close without pressing on the plug or the cable.