Description
The FormulaMod Fm-BZXZ-ASUS is an 18 AWG sleeved cable kit for fully modular desktop power supplies. It replaces the original DC cables and includes combs to keep the individual wires aligned. Choose a kit by cable length and connector count, and confirm that your PSU manufacturer permits this exact kit before ordering.
Check the exact PSU model and revision before ordering.
PSU compatibility for this kit is unverified. Modular pin assignments can differ between power supplies even when the connectors look alike. Use this kit only if your PSU manufacturer confirms it for your exact model and permits its use.
ASUS advises using the original modular cables and requires them for the ROG-THOR-850P and ROG-THOR-1200P. Seasonic’s installation guide directs users to use only the original modular cables supplied with their PSU.
The motherboard cable has two plugs at the PSU end and one 24-pin plug at the motherboard end. Confirm compatibility with your exact PSU model before connecting either end.
Each wire has its own braided sleeve. Use the included combs to keep the wires parallel along visible runs.
| Model | Fm-BZXZ-ASUS |
|---|---|
| Cable type | Direct replacement for fully modular PSU cables |
| Wire gauge | 18 AWG |
| Individual wire outer diameter | 3 mm |
| Construction | Individual braided sleeves over insulated wires |
| Component-side connectors | ATX 24-pin, EPS 4+4-pin, PCIe 6+2-pin, SATA power, Molex 4-pin |
Each version has its own PSU-side connector layout. Read the model number from the PSU label. If the revision is unclear, ask the PSU manufacturer to identify it and confirm cable compatibility.
Each kit includes 24-pin and 8-pin cable combs. The standard kits omit the SATA splitter.
| ATX 24-pin | A / A+ 1 × 650 mm B 1 × 400 mm |
|---|---|
| EPS 4+4-pin | A / A+ 1 × 850 mm B 1 × 650 mm |
| PCIe 6+2-pin | A 2 × 650 mm A+ 3 × 650 mm B 2 × 400 mm |
| SATA power | A / A+ 1 × 350 mm and 1 × 500 mm B 1 × 400 mm and 1 shorter cable |
| Molex 4-pin | A / A+ 1 × 350 mm and 1 × 400 mm B 1 × 350 mm |
You’ll need a fully modular PSU confirmed for this kit and components with the corresponding power inputs.
Read the model number from the PSU label. If the revision is unclear, ask the PSU manufacturer to identify it and confirm cable compatibility. Keep using the original cables unless the manufacturer confirms this kit for that unit.
Kit A+ adds one 650 mm PCIe 6+2-pin cable. The other cables have the same lengths and quantities.
Kit B has shorter ATX, EPS, and PCIe leads than Kit A or A+. Measure the cable route in your case and compare it with the lengths above.
The kits use PCIe 6+2-pin GPU cables. A 16-pin GPU cable is not included.
The standard A, A+, and B kits include two SATA power cables each. The SATA splitter is not included.