Description
The FormulaMod Fm-NCK1 kit adds 300 mm of two-tone sleeved cable to the component ends of your original PC power supply leads. It gives the visible motherboard and graphics card wiring a coordinated look. Choose a kit by the ATX, CPU EPS, and GPU PCIe connectors your build needs.
Connect each extension to the matching component end of its original PSU lead.
Never insert an extension directly into a modular PSU socket. Use the EPS and PCIe connectors only for their designated sockets.
Check the connector types, counts, and latch positions before ordering. ATX and EPS cables bend toward the latch side. PCIe cables bend away from it.
The braid combines black with blue, green, orange, purple, or red. Choose the color pair you want on the cables visible inside your case.
The inner and outer rows of wire are sized for the curve so the sleeves line up through the bend. Two combs per cable hold the wires in position.
| Series model | Fm-NCK1 |
|---|---|
| Extension length | 300 mm (11.8 in) |
| Wire gauge | 18 AWG |
| Cable diameter | 3 mm |
| Cable construction | Braided sleeve over an insulated conductor |
| Housing references | 5557 / 5559 (FormulaMod) |
| Pre-bend | 180° |
| Kit options | A, B, C, D, E, F, G, H |
| Kit A | 1 × ATX 24-pin, 1 × EPS 8-pin, 2 × PCIe 8-pin |
|---|---|
| Kit B | 1 × ATX 24-pin, 1 × EPS 8-pin, 2 × PCIe 6-pin |
| Kit C | 1 × ATX 24-pin, 1 × EPS 8-pin, 1 × PCIe 8-pin, 1 × PCIe 6-pin |
| Kit D | 1 × ATX 24-pin, 1 × EPS 8-pin, 1 × PCIe 8-pin |
| Kit E | 1 × ATX 24-pin, 1 × EPS 8-pin, 1 × PCIe 6-pin |
| Kit F | 1 × ATX 24-pin, 2 × EPS 8-pin, 2 × PCIe 8-pin, 2 × PCIe 6-pin |
| Kit G | 1 × ATX 24-pin, 1 × EPS 8-pin, 2 × PCIe 8-pin, 2 × PCIe 6-pin |
| Kit H | 1 × ATX 24-pin, 1 × EPS 8-pin, 3 × PCIe 8-pin |
Choose the kit letter by connector count, then pick the sleeve color.
Use the Cable Counts by Kit table to check the exact contents of your selection.
You need your PSU’s original component cables and the matching sockets on your motherboard or GPU.
Plug them into the component ends of your original PSU leads. Keep the original leads attached to the PSU.
Kit A has two PCIe 8-pin (6+2) leads, one ATX 24-pin and one CPU EPS 8-pin. Kits F and G also have two 8-pin GPU leads and add two PCIe 6-pin leads.
Every kit uses 300 mm (11.8 in) extensions.
Choose Black x Green for green and black threads woven into each sleeve. It is available in Kits A through H.