Bykski · Installation tutorial
Replace Your GPU’s Stock Cooler with a Full-Cover Water Block
The Bykski video shows how to place thermal pads and mount a full-cover water block on a bare graphics card PCB. This page also explains how to match the block to your exact card model and PCB layout before disassembly, remove the stock cooler, and leak-test the custom loop before powering on the card.
Setup
Custom liquid cooling loop
Have ready
Your block’s installation manual
Before You Remove the Stock Cooler
Example board from the Bykski tutorial.
Confirm the card and PCB layout
Check the block maker’s compatibility listing for your exact graphics card and match its PCB layout before you remove the cooler.
Example assembly. The water block sits above the PCB and the backplate sits below it.
Identify the mounting hardware
Lay out the screws, washers, and any standoffs shown in your block’s installation manual. Use that manual for the screw positions and backplate assembly.
What to Check in Your Block Manual
| Thermal pad map | The locations and pad thicknesses for the front of the PCB and the backplate, where specified. |
|---|
| Mounting sequence | The specified fasteners and tightening order for your block and backplate. |
|---|
| Loop connections | The water block’s inlet and outlet and the fittings to use. |
|---|
What You’ll Need
A compatible water block and its mounting hardwareThe thermal materials specified in the block manualA custom loop with a pump, radiator, fittings, tubing, and coolant
Installation & Use
1Remove the graphics card. Shut down the computer and unplug its power cord. Disconnect the graphics card’s power cables before removing the card.
2Remove the stock cooler. Follow the instructions for your card. Keep track of where each screw goes, and unplug any cooler cables before lifting the cooler away.
3Prepare the contact surfaces. Remove the old pads and clean off the old thermal material. If your block manual calls for you to install loose thermal pads, peel off the protective film from both sides and apply the pads where the manual specifies. If the manual calls for thermal paste, apply it to the GPU contact surface.
4Mount the water block. Align the block and PCB mounting holes. Use the specified fasteners and tighten them evenly in the order shown in the manual. Install the backplate if your block uses one.
5Reinstall the card and connect the tubing. With the computer still unpowered, put the graphics card back in the case. Use the block manual to identify the inlet and outlet, connect the tubing, and fill the loop with coolant.
6Leak-test before powering the graphics card. Run only the pump and check the ports and fittings for leaks. If you find one, shut the pump off immediately. Fix the leak and let any affected hardware dry completely before retesting. Power on the computer once the loop passes the test and all hardware is dry.
FAQ
How do I check whether a water block fits my graphics card?
Look up the full card model in the block maker’s compatibility listing and compare the PCB layout to your card. Check the block revision before choosing its installation guide.
Where do the thermal pads go on the graphics card?
Use your block’s pad map to identify the memory (VRAM) and power delivery contact points that need pads. Use the thickness shown for each location.
How tight should I make the mounting screws?
Tighten the screws evenly in the sequence shown in your block’s manual. Follow any torque guidance given for that revision.
Should the graphics card have power during a leak test?
Keep the graphics card and the rest of the system unpowered. Supply power only to the pump while you check the loop for leaks.
Notes- Do not purchase this link, only for viewing the tutorial video
- Find “Bykski GPU block installation general tutorial” on the FormulaMod Official Studio YouTube channel.
- As GPU block products have been upgraded and changed.
- The steps shown in the tutorial video may have been different from the actual operation of the new version of the GPU block.
- Please refer to it as appropriate, but the general installation ideas are common. And please install it in conjunction with the video and the installation instructions of the target GPU block.