PC Water Cooling Leak Tester – Granzon GYB II with Digital Display

Granzon · GYB II

Automatic air leak testing for custom PC water cooling

The Granzon GYB II is an automatic air pressure leak tester for custom PC water cooling loops. Connect it to an assembled, empty loop to check for leaks before adding coolant. One button starts the test, and the digital display shows the pressure, test progress, and result.

Fits
Custom PC water cooling loops
Test medium
Air
Operation
One-button start
Display
Digital

Use With

An assembled custom PC water cooling loop with an accessible test port.

Before ordering, confirm that the included loop-side fitting matches the threads on your test port. The loop should be empty of coolant and sealed at every other opening.

Design Highlights

Start the test with one button

Use the round button beside the screen to start the automatic test. The tester pressurizes the loop with air and displays a report when the cycle ends.

One-piece metal housing

The test tube connects at the side of the housing, with the screen and start button on the top face.

Key Specifications

ModelGYB II
Test mediumAir
OperationAutomatic test with one-button start
DisplayDigital pressure gauge, countdown, and test report
HousingOne-piece metal
Dimensions76.30 × 62.00 × 40.50 mm

Manufacturer drawing in millimeters. The length includes the side fitting. The button projects 2.25 mm above the housing.

Automatic or Manual Leak Tester?

Granzon GYB IITHIS PAGE
Choose this tester for one-button operation and an on-screen report.
Choose this model if you prefer to pressurize the loop by hand.

What's in the Box

1 × Granzon GYB II leak tester2 × push fittings1 × test tube

Manufacturer kit illustration.

Installation & Use

1
Assemble the loop and leave it empty. Seal all openings except the port you will use for the test.
2
Use the test tube and push fittings to connect the tester to that port. Check that both ends are seated securely.
3
Press the start button and let the automatic cycle finish. Read the result on the display.
4
If the test indicates a leak, check the tester connections and loop seals, then retest.
5
Once testing is complete and the loop is depressurized, remove the tester and close the test port before adding coolant.

Manufacturer illustration of the test tube connected to an example loop.

FAQ

When should I air-test the loop?

Run the test after assembling and sealing the loop and before adding coolant.

What can I see on the display while the test runs?

It shows a pressure gauge with a psi scale, the motor start and test countdowns, and the pressure sensor load.

What does the report show after the test?

The report lists the test time, volume in mL, and the difference between the highest and lowest pressure readings in bar. The tester then shows its result.

What should I check if the test indicates a leak?

Check both ends of the test tube as well as the loop fittings and seals. Run the test again after correcting the connections.

Notes
  • Follow the pressure limits specified by the manufacturers of your loop components.