29%OFF

Extreme Odyssey Thermal Pad by Thermalright, 12.8 W/mK, 1 / 1.5 / 2 mm

Thermalright · Extreme Odyssey

Cut-to-fit thermal pad for heatsink contact

The Thermalright Extreme Odyssey is a silicone thermal pad that fills the gap between a heat-producing component and its heatsink. Use it at designated pad locations on graphics cards, memory modules, and SSDs. It is electrically nonconductive and has a manufacturer-rated thermal conductivity of 12.8 W/mK.

Thermal conductivity
12.8 W/mK
Thickness options
1 mm / 1.5 mm / 2 mm
Material
Silicone
Fits
Designated heatsink pad locations

Where to Use It

Thermalright lists these applications for Extreme Odyssey.

  • ✓Graphics card heatsink pad locations
  • ✓DRAM module heatsinks
  • ✓SSD heatsinks

Before ordering, check the thickness and placement for each pad location in your device or cooler manual. A single heatsink can specify several pad thicknesses.

Design Highlights

The arrow points to the thermal pad at the heatsink contact surface.

Thermal contact across the gap

The pad compresses when the heatsink is mounted, maintaining contact between the component and the cooler when you use the specified thickness.

Trim the sheet to the contact area

Use scissors to cut the pad to the length and width specified for each contact area. Choose the thickness before cutting.

Key Specifications

ModelExtreme Odyssey Thermal Pad
Thickness / store SKU1 mm (EOTP-1)
1.5 mm (EOTP-1.5)
2 mm (EOTP-2)
MaterialSilicone
Thermal conductivity12.8 W/mK
Electrical conductivityNonconductive
Dielectric breakdown9.8 kV at 1 mm
ColorGray
Density3.1 ± 0.2 g/cm³
Hardness30–55 Sc
Pad propertiesNoncorrosive and noncuring

Untrimmed thermal pad sheet.

Which Version Do I Need?

Check the required thickness and pad shape in your cooler’s instructions.

Extreme OdysseyTHIS PAGE
Choose a 1, 1.5, or 2 mm sheet rated at 12.8 W/mK if you need to cut the pad to fit.
Choose this pre-cut 1.5 mm strip rated at 6 W/mK if it matches your cooler’s pad specifications.

What's in the Box

Thermalright Extreme Odyssey thermal pad in the selected thickness

Installation & Use

1
Check your cooler’s pad placement and thickness instructions before removing it.
2
Remove the old pad and clean the contact surfaces as directed by the cooler manufacturer.
3
Cut the new pad to the required contact area with scissors.
4
Peel away any protective film from both sides and place the pad at the specified location.
5
Reinstall the heatsink following the cooler manufacturer’s instructions.

Have scissors and the tools specified for your heatsink on hand.

FAQ

How do I choose between 1 mm, 1.5 mm, and 2 mm?

Use the thickness specified for the exact pad location on your device or cooler.

What is the thermal conductivity?

Thermalright specifies 12.8 W/mK for all three thicknesses offered here.

Is the pad electrically conductive?

The pad is electrically nonconductive.

Can I cut it to size?

Yes. Use scissors to trim the sheet to the contact area before placing the pad.

Which Extreme Odyssey generation is this?

This listing is for the original Extreme Odyssey thermal pad. Thermalright lists Extreme Odyssey II as a separate series.

Notes
  • Do not swallow. Keep away from children.