Description
The Bykski CP-DWPB-X is a stand-alone pump that circulates coolant between the reservoir, water blocks, and radiator in a custom PC loop. It runs on 12 V DC power and supports PWM speed control with RPM feedback. Bykski specifies a maximum flow of 1,400 L/h and a maximum head of 15 m.
Check clearance for the pump body, fittings, and tubing before choosing a mount.
The black POM top carries the two threaded coolant ports. The aluminum alloy housing surrounds the motor.
Bykski’s standard wiring diagram shows a 4-pin Molex power connector and a separate four-position PWM connector for speed control and RPM feedback. Before ordering, check which connectors ship with the pump and whether they match your power supply and PWM controller.
| Model | CP-DWPB-X |
|---|---|
| Pump top | Black POM |
| Outer housing | Aluminum alloy |
| Shaft | Ceramic |
| Motor drive | Sine wave |
| Maximum flow | 1,400 L/h |
| Maximum head | 15 m |
| Rated voltage | 12 V DC |
| Rated current | 4 A |
| Input power | 48 W |
| Maximum input current | 5 A |
| Speed control | PWM with RPM feedback |
| Port threads | G1/4 female |
| Overall height | 95.50 mm |
| Width at mounting tab | 74.00 mm |
| Body diameter | 71.50 mm |
Compare the published flow and head of these stand-alone pumps when sizing your loop.
For a new loop, you also need a separate reservoir, G1/4 fittings, matching tubing, coolant, water blocks, a radiator, and fans.
That is Bykski’s maximum flow figure. Actual flow depends on the resistance of your loop.
The motor is rated for 12 V DC and has a maximum input current of 5 A. Check that your power supply matches the pump’s power connector before connecting it.
Yes. A compatible PWM header can control the pump speed and read RPM.
Use male G1/4 fittings. Match the tubing side of each fitting to the tubing you use.
Prime the pump with coolant before turning it on. Keep the reservoir topped up while you bleed the loop to prevent dry running.